Chart Detail Level; Map Borders; Lat/Lon Grid; Set Simulation Position - Humminbird 383c Operation Manual

531450-1_A - 383c_Eng.qxd 11/18/2005

Chart Detail Level

Chart Detail Level allows you to select how much chart
detail you want displayed on the Navigation Views. Basic shows land areas, ports,
obstructions and restricted areas. Navigation shows navaids, landmarks, ferryways and
navigation routes in addition to the Basic information. Underwater shows depth
contours, fishing areas, underwater wrecks, tides and currents in addition to the Basic
and Navigation information. All shows roads, buildings, railways, and other notations in
addition to the Basic, Navigation and Underwater information.
To change the Chart Detail Level setting:
1. Highlight Chart Detail Level on the Chart main menu.
2. Use the LEFT or RIGHT 4-WAY Cursor Control keys to change the Chart Detail
Level setting. (Basic, Navigation, Underwater, All, Default = All)
NOTE: Some chart details are only available with optional-purchase MMC/SD cards.

Map Borders

Map Borders allows you to display or hide map borders.
A Map Border indicates an area which contains a different map.
Map Borders
To change the Map Borders setting:
1. Highlight Map Borders on the Chart main menu.
2. Use the LEFT or RIGHT 4-WAY Cursor Control keys to change the Map Borders
setting. (Hidden, MMC/SD Only, All Visible, Default = Hidden)
2:37 PM Page 74
Map Borders
67

Lat/Lon Grid

Lat/Lon Grid allows you to display or hide a grid
showing latitude and longitude lines.
To change the Lat/Lon Grid setting:
1. Highlight Lat/Lon Grid on the Chart main menu.
2. Use the LEFT or RIGHT 4-WAY Cursor Control keys to change the Lat/Lon Grid
setting. (Hidden, Visible, Default = Hidden)

Set Simulation Position

(Advanced)

Set Simulation Position allows you to set the position of the boat used in the Simulator.
The Set Simulation Position menu choice is only available when User Mode is set to
Advanced (see Setup Menu Tab: User Mode).
To set the Simulation Position:
1. Activate the cursor and move it to the coordinates from where you want the
simulation to start.
NOTE: The cursor must be active in order for this procedure to work.
2. Make sure you are in Advanced User Mode, then highlight Set Simulation
Position on the Chart main menu.
3. Use the RIGHT 4-WAY Cursor Control key to change the Simulation Position
setting. A confirmation dialog box will appear to allow you to change your
mind, or to confirm your choice. If the cursor was not active before you began
this procedure, you will see an error message. Exit the menu, set the cursor, then
try again.
68