Select Readouts (Advanced, Sonar View Only); Depth Offset - Humminbird 383c Operation Manual

531450-1_A - 383c_Eng.qxd 11/18/2005
Select Readouts
(Advanced, Sonar view only)
Select Readouts sets individual digital readouts on the
Sonar View. This Advanced feature allows you to select
what data will be displayed in each of 5 fixed-position
data windows arranged around the left and bottom
edges of the Sonar View screen, or whether a particular
window will be turned off, displaying nothing in that
area; you can access this menu choice only when in
Advanced User Mode (see Setup Menu Tab: User Mode.)
Select Readouts
Data windows can display readouts from supported
accessories such as Temp/Speed. Each data window can
either be empty or contain one of the following:
• Course
• Navigation
• Position
• Speed
Default Sonar View
2:38 PM Page 86
• Temperature
• Time + Date
• Triplog
• Voltage.
Customized Sonar View
79
To Select Readouts:
1. Make sure you are in Advanced User Mode, then highlight Select Readouts on
the Setup main menu.
2. Use the RIGHT 4-WAY Cursor Control key to initiate this procedure.
3. The Select Readouts submenu will appear, showing a list of all Readouts. Use
the UP or DOWN Cursor keys to select a particular Readout position, then use
the RIGHT or LEFT Cursor keys to change what will be displayed at that
position. (Course, Navigation, Position, Off, Speed, Temperature, Time+Date,
Triplog, Voltage)

Depth Offset

(Advanced)
Depth Offset will adjust the digital depth readout to indicate depth from the waterline
or boat's keel. Enter a positive vertical measurement from the transducer to the
waterline to read the depth from the waterline. Enter a negative vertical measurement
from the transducer to keel to read the depth from the keel. This menu choice is
available only when in Advanced User Mode (see Setup Menu Tab: User Mode.)
To change the Depth Offset setting:
1. Make sure you are in Advanced User Mode, then highlight Depth Offset on the
Setup menu.
2. Use the LEFT or RIGHT 4-WAY Cursor Control keys to change the Depth Offset
setting. (-10.0 to +10.0 feet or -3 to 3 meters [International Models only],
Default = 0)
80