Preparation For Installation And Wiring - Delta Electronics VFD-DD Series User Manual

Chapter 1 Introduction |DD Series

1-2 Preparation for Installation and Wiring

Install the AC motor drive in an environment with the following conditions:
Operation
Storage
Transportation
Pollution Degree
Minimum Mounting Clearances
The drive installation can be on a platform or on the wall. The left and middle figures show the
drive installation on a platform from the front and the side-view. The right figure shows wall
mounting. Both platform mounting and wall mounting are required to keep minimum mounting
clearances for good ventilation.
A
20mm
Air Temperature:
Relative Humidity:
Atmosphere pressure: 86 ~ 106 kPa
Installation Site
Altitude:
Vibration:
Temperature:
Relative Humidity:
Atmosphere pressure: 86 ~ 106 kPa
Vibration:
2: can be used in a factory type environment.
B
15mm
-10 ~ +45°C (14 ~ 113°F)
<90%, no condensation allowed
<1000m
2
<20Hz: 9.80 m/s (1G) max
2
20 ~ 50Hz: 5.88 m/s (0.6G) max
-20°C ~ +60°C (-4°F ~ 140°F)
<90%, no condensation allowed
2
<20Hz: 9.80 m/s (1G) max
2
20 ~ 50Hz: 5.88 m/s (0.6G) max
C
20mm
1-4
D
8mm