Optional Accessories; Unpack Your Furnace - Williams 4007332 Owner's Manual

Introduction

Optional Accessories

SIDE OUTLET GRILLE KIT 6701
Let‟s you route some heated air into a second room. Mounts on
the side wall of second room and must be within 10 inches of wall
furnace. See pages 7 and 10.
DIFFUSER GRILLE KITS 6703 & 6704
Let‟s you route some heated air in a two-way direction. Kit 6704
for one-way direction.
SIDE GRILLE KIT 6702

Unpack Your Furnace

The furnace is shipped in two cartons, one containing the furnace,
installation instruction booklet and hardware bag and the other
containing the vent cap with inlet and vent tubes.
1. Lay the carton horizontally.
2. The bottom front panel can be removed by grasping just below
the handle and pulling it outward and then upward. See Fig. 1.
3. Place these and other parts, as they are removed from
furnace, where they cannot be lost or damaged before you
need them.
NOTE
Check the burner rating plate, located in burner compartment, to
make sure your furnace is equipped to operate on the type of gas
available (either Natural or L.P. Gas). Do NOT convert the unit
from Natural Gas to L.P. Gas or from L.P. Gas to Natural.
4. Remove all literature and package containing thermostat, wire
and metal anchors used for free standing installation.
5. Check the fan blade to be sure it spins freely.
6. Take out the four screws holding fan shroud to the side
flanges of cabinet and remove shroud. See Figure 1.
NOTE
The fan blade must be removed in order to remove the cardboard
shipping brace located under motor.
7. Before removing the fan blade, remember its position by
examining the blade nut and the amount of shaft visible.
Scribe or mark the motor shaft in order to reinstall the fan
blade to its original place on the shaft.
8. Loosen the 1/8" "Allen head" set screw holding the fan blade
to motor shaft and remove the fan. Place the fan blade and
fan shroud where they will not be damaged.
9. Remove the cardboard shipping brace located under the
motor mounting brackets.
10. Properly dispose of shipping materials.
6
Let‟s you route some heated air to side of furnace in the same
room. See pages 7 and 10.
TRIM STRIP KIT 4701
Provides a finished edge at sides of wall furnace. Neutral beige
enamel painted steel.
Note: Kits are identified on the carton by manufacturing number
6701, 6702, 6703 and 6704 are also listed on the furnace rating
plate.
FIGURE 1