Optional Accessories; Unpack The Furnace - Williams 3508232 Owner's Manual

Introduction

Optional Accessories

DIFFUSER GRILLE KITS 6703 & 6704
Let's you route some heated air in a two-way direction. Kit 6704
for one-way direction.
SIDE OUTLET GRILLE KIT 6702
Allows you to direct heated air from the side of furnace into the
same room.
OUTLET GRILLE REGISTER 6701
Let's you route some heated air into a second room. Mounts on
the side wall of second room and must be within 10 inches of wall
furnace.
REAR OUTLET KITS 6801 & 6802
Let's you route some heated air into a second room behind the
furnace. Finished wall of second room must be within 10 inches of
furnace as shown on Page 8, Fig. D. Built-in damper lets you shut
off air flow to second room if desired.
Unpack Your Furnace
The furnace is shipped in one carton containing the furnace,
installation instruction booklet and hardware bag.
1. Lay carton horizontally. Open carton and remove top trim
cover from its packing. Remove thumb screw at top of
furnace, raise top front panel ½ inch and remove panel from
cabinet. This is so you can get to the electrical connections
later.
2. Place these and other parts, as they are removed from
furnace, where they cannot be lost or damaged before you
need them.
3. Bottom front panel can be removed by grasping just below
handle and pulling it outward and then upward. See Fig. 1.
NOTE
Check the burner rating plate, located in burner compartment, to
make sure your furnace is equipped to operate on the type of gas
available (either Natural or L.P. Gas). Do NOT convert unit from
Natural Gas to L.P. Gas or from L.P. Gas to Natural
4. Remove all literature and package containing thermostat, wire
and metal anchors used for free standing installation.
5. Check the fan blade to be sure it spins freely.
6
OVAL VENT KIT 9901
This U.L. listed B/W vent kit contains 4 feet of oval double walled
vent pipe, plate spacers and starter or hold-down plate that starts
the venting from the top of the furnace. See page 16 for additional
items you will need.
VENT ENCLOSURE KITS 9812 or 9824
These kits are used only when the furnace is surface mounted.
They enclose the vent pipe from the top of the surface to the
ceiling.
TRIM STRIP KIT 4701
Provides finished edge at sides of wall furnace. Neutral beige
enamel painted steel.
FIGURE 1