IDVIEW IV-1600TX-SN Installation & Operation Manual page 82

R10/ Selects "CH10" to display in PIP, Quad, 2x2, 3x3, or 4x4 format
R11/ Selects "CH11" to display in PIP, Quad, 2x2, 3x3, or 4x4 format
R12/ Selects "CH12" to display in PIP, Quad, 2x2, 3x3, or 4x4 format
R13/ Selects "CH13" to display in PIP, Quad, 2x2, 3x3, or 4x4 format
R14/ Selects "CH14" to display in PIP, Quad, 2x2, 3x3, or 4x4 format
R15/ Selects "CH15" to display in PIP, Quad, 2x2, 3x3, or 4x4 format
R16/ Selects "CH16" to display in PIP, Quad, 2x2, 3x3, or 4x4 format
E1/ Displays "CH1" on the Call monitor
E2 Displays "CH2" on the Call monitor
E3 Displays "CH3" on the Call monitor
E4 Displays "CH4" on the Call monitor
E5 Displays "CH5" on the Call monitor
E6 Displays "CH6" on the Call monitor
E7 Displays "CH7" on the Call monitor
E8 Displays "CH8" on the Call monitor
E9 Displays "CH9" on the Call monitor
E10 Displays "CH10" on the Call monitor
E11 Displays "CH11" on the Call monitor
E12 Displays "CH12" on the Call monitor
E13 Displays "CH13" on the Call monitor
E14 Displays "CH14" on the Call monitor
E15 Displays "CH15" on the Call monitor
E16 Displays "CH16" on the Call monitor
ES Same as "Call" + "Seq." buttons
ESQ Auto-sequencing on the Call monitor
SQ Auto-sequencing on the Main monitor
VR Enters into playback mode
PX Enters into Live display (Exit playback mode)
FL Displays
ZM Displays Zoom mode
IP Displays
QD Displays
NE Displays
HX Displays
Control Command Codes
These Control Command codes are used to perform specific functions to control one or more than
one unit via the RS-232 & RS-485 ports from a host computer.
full screen format
format
format
format
format
80