Table of Contents
Advertisement
1. Click the
button to control the Zoom setting on the Speed Dome Controller.
2. The right-hand set,
the way, without stopping, in one of the four designated directions. The fifth button, in the center, will stop
the camera at any point you prefer.
3. The left-hand set of buttons,
one short step only in any of the four designated directions.
4. Select a Speed Dome device Model
Controller. The Controller will display the corresponding Model.
5. Select a Speed Dome device ID
The Controller will display the corresponding ID .
6.
Each of the ten buttons under 'Set' is connected with a specific position and angle of either panning or
tilting of the camera. Click each button to activate its particular position and angle. Press the button under
'Preset' to turn the camera angle by angle in the set positions.
Each of the ten buttons under 'Clear' can be clicked to delete the corresponding 'Set' button above it. For
example, if you wish to de-activate 'Set' button #4, please click 'Clear' button #4 to delete its
corresponding 'Set' counterpart.
Each of the ten buttons designated 'Go to' can be clicked to view the particular corresponding angle of the
position in which it is set.
7.
The 'AutoPan' section
panning movement you select. The third or bottom button sets the chosen movement in the play mode.
, has four buttons, each of which, upon being clicked, will turn the camera all
, has four buttons, each of which, upon being clicked, will move
from the drop-down list on the Speed Dome Controller.
has three buttons. The 'Start' and 'End' buttons fix the two points of any
66
from the drop-down list on the Speed Dome
Advertisement
Table of Contents
