Table of Contents
Advertisement
NOTE: Hard-disk drives not shown on this list have not been tested by our engineering team
and are not recommended for use with this product. For the latest updated list on the
recommended hard disk drives, please contact your dealers or distributors.
3.3 Built-in hard disk
To install the two hard disks please take the following steps:
1.
Loosen the mounting
screw on one of the mobile
racks of the DVR and
detach it.
5.
Secure the driver in the
rack using 4 mounting
screws in the
side-mounting holes.
Please don't tighten the
screws too much,
otherwise that may
damage the driver.
2.
Draw out the mobile rack
from the DVR.
6.
Place the mobile rack back
onto the device and screw
in the screw.
3.
Setting the jumper of your
HD1 driver: The way to set
the jumper of the drive
varies between
manufacturers; please
refer to the instructions on
the driver to set the
jumpers in the master
position.
7.
Attach the interface
connector and the power
connector to the drive.
Please note the red lining
of the IDE cable and the
red wire of the power cable
must line up side by side.
13
4.
Place the hard disk in the
rack.
8.
Loosen the mounting
screw on the other mobile
rack of the DVR and
detach it.
Advertisement
Table of Contents
