Table of Contents
Advertisement
9.
Draw out the mobile rack
from the DVR.
13.
Place the mobile rack back
onto the device and screw
in the screw.
10.
Setting the jumper of your
HD2 driver: The way to set
the jumper of the drive
varies between
manufacturers; please
refer to the instructions on
the driver to set the
jumpers in the slave
position.
14.
Attach the interface
connector and the power
connector to the drive.
Please note the red lining
of the IDE cable and the
red wire of the power cable
must line up side by side.
11.
Place the hard disk in the
rack.
15.
The installation of the hard-disk drive is complete.
14
12.
Secure the driver in the
rack using 4 mounting
screws in the
side-mounting holes.
Please don't tighten the
screws too much,
otherwise that may
damage the driver.
Advertisement
Table of Contents
