Kenmore 253 Series Use & Care Manual page 13

ICE AND WATER DISPENSER FEATURES
The ice and water dispenser conveniently dispenses chilled water, and ice
cubes or crushed ice, depending on the model.
To operate the ice dispenser, select the ice option desired using the
touchpad. Press a glass against the dispensing paddle as far up as
possible to catch all ice. To stop dispensing ice, pull glass away from
dispensing paddle. Do not remove the glass until the ice has completely
dispensed. (Complete instructions for the dispenser operation are attached
to the inside of the freezer door.)
To operate the water dispenser, press a glass against the dispensing
paddle. To stop dispensing water, pull glass away from dispensing paddle.
A drip tray located at the base of the dispenser, catches small spills and
allows them to evaporate. This drip tray is removable and dishwasher
safe. Do not pour water or excess cubes into this area because there
is no drain.
Dispenser Light (some models)
The dispenserhas a lightwhich can be turned on and off by pressingthe
Light touchpad.The light also turnson automaticallywhen ice and/or water
is dispensed. Replace light bulb with an appliance bulb of the same wattage.
Filtered Ice and Water
CUBE
Ice and Water Dispenser Panel (features may vary according to model)
How the Water Dispenser Works
The water tank, located behind the drawers in the refrigerator compartment, automatically fills as water is dispensed.
For proper dispenser operation, the recommended supply water pressure should fall between 20 psi and 100 psi.
After the refrigerator is connected to the water supply, fill the water tank by drawing one glass of water. It may take
about 11/2 minutes after activating the dispenser paddle before water begins to fill this first glass. Continue flushing
the system for 3 minutes to rid the tank and plumbing connections of any impurities. The water dispenser has a built in
shutoff device that will stop the water flow after 3 minutes of continuous use. Simply release the dispenser paddle to
reset the shutoff mechanism.
How the Ice Dispenser Works
The ice maker and container are located in the top of the freezer compartment. After the refrigerator is installed properly
and has cooled for several hours, the ice maker can begin making ice within 24 hours. Air in new plumbing lines may
cause the ice maker to cycle two or three times before making a full tray of ice. To begin ice production, lower the wire
signal arm to the "down" or ON position. With no usage it will take approximately 2 days to fill the ice container. The ice
maker turns off automatically when the ice container becomes full. To stop the ice maker, lift the wire signal arm until it
clicks, and locks in the "up" or OFF position.
Because of new plumbing connections, the first production of ice cubes may be discolored or have an odd flavor. These
should be discarded until the cubes made are free of discoloration and taste.
13