Troubleshooting Guide - Heath Zenith SL-4300 Manual

If you experience a problem with your porch light, follow this guide before returning it to the retailer.
SYMPTOM POSSIBLE CAUSE
Light will not
1. Light switch is turned off.
come on. 2. Bulbs are loose or burned out.
3. Fuse is blown or circuit breaker
is turned off.
4. Daylight turn-off is in effect (re-
check after dark) .
5. Incorrect circuit wiring, if this is
a new installation.
Light comes on
1. Sensor may be installed in a
in daylight.
relatively dark location.
2. Sensor is in Test. (Set control
switch to an ON-TIME position.)
Light comes on
1. Sensor may be sensing small
for no apparent animals or automobile traffic. (Re-
reason. duce sensitivity.)
2. Sensitivity is set too high. (Re-
duce sensitivity.)

TROUBLESHOOTING GUIDE

No Service Parts Available for this Product
See your Canadian Tire retailer for warranty information.
SYMPTOM POSSIBLE CAUSE
Light stays on 1. There is a heat source like an air
continuously.
2. Light control is in Manual Mode.
3. Light control is in Dual Brite™
Light flashes on 1. Sensor is in the Test mode.
and off.
2. Heat being reflected from other
Light does not 1. Nearby large, light-colored ob-
stay on in
Manual mode.
6
vent, dryer vent, or brightly-
painted, heat-reflective surface
in the coverage area. (Install
shield on sensor in the direction
of heat source.)
(Switch to Auto.)
mode.
(While in TEST mode, light only
stays on for 5 seconds.)
objects may be affecting the
sensor. (Re-aim sensor.)
jects reflecting light may trigger
the shut-off feature. Do not point
other lights at the sensor.
598-1208-00