Table of Contents
Advertisement
Available languages
Available languages
IMPORTANT: keep sensor switch in the "OFF"
position for 3 to 7 days to allow the battery to fully
charge before testing.
Tab Slots
Rechargeable
Battery
Battery
Cover
Battery Cover Catch Release
SyMPtOM
Lights will not come on.
Lights come on in daylight.
Lights come on for no appar-
ent reason.
Lights stay on continuously. 1. Light control is pointed toward a heat source
Lights flash on and off.
598-1344-03
Positive Wire
Negative Wire
trOuBLeShOOtIng guIDe
POSSIBLe CauSe
1. Battery is dead.
2. Sensor is turned OFF.
3. Daylight turn-off is in effect.
4. Incorrect aiming.
1. Light control may be installed in a relatively
dark location.
2. Light control is in TEST.
1. Light control may be sensing small animals
or automobile traffic.
2. Range is set too high.
like an air vent, dryer vent, or brightly-colored
heat-reflective surface.
2. Light control is in TEST.
1. Heat or light from the lamp may be turning
the light control on and off.
2. Heat being reflected from other objects
may be affecting the sensor.
3. Light control is in the TEST mode and
warming up.
4. Battery is almost dead.
SPeCIFICatIOnS
Range ........................... Up to 70 ft. (21 m); [varies with
Sensing Angle .............. Up to 180°
LED (x3) ....................... 7.8 watts
Battery Type.................. Sealed lead acid, 6 V 5.5 A-Hr.
On Time ........................ TEST (5 seconds), 1 or 5 min-
Full Charge on Time ..... Up to 1 hour
IMPORTANT: DO nOt reverse the battery wires. Dam-
age to the unit will result. Like any lead-acid battery,
this battery must be disposed of properly.
HeathCo LLC reserves the right to discontinue products
and to change specifications at any time without incurring
any obligation to incorporate new features in products
previously sold.
SOLutIOn
1. Switch the sensor OFF and let the battery charge
for 3 to 7 sunny days before using again.
2. Turn sensor ON.
3. Recheck after dark.
4. Re-aim the sensor to cover desired area.
1. Relocate light control to an area that receives
more light.
2. Set control switch to 1 or 5 minute position.
1. Re-aim sensor.
2. Reduce RANGE.
1. Reposition sensor.
2. Set control switch to 1 or 5 minute position.
1. Reposition the lamps away from the sensor.
2. Reposition sensor.
3. Flashing is normal under these conditions.
4. Reduce RANGE. If flashing continues, switch
the sensor OFF and let the battery charge for
three or more sunny days before using again.
5
surrounding temperature]
utes, OFF, selectable
Advertisement
Table of Contents
