Table of Contents
Advertisement
OVEN PROBLEM
Oven does not function
Self-clean cycle does not activate Door is not shut tight and door latch cannot lock
Door does not open
Oven light does not work
Oven door is locked and will not
release after cooling
Oven is not heating
Oven light is not working properly Replace or reinsert the light bulb if loose or defective.
Oven light stays on
Cannot remove light cover
Broil does not work
PRE-HEATING indicator lights up
intermittently and sound alarm on
HEATING indicator light turned
on intermittently and with sound
alarm on
CLEAN indicator light on
intermittently and sound alarm on
CLEAN indicator light turned on
intermittently, sound alarm off
PRE-HEATING indicator light on
intermittently, sound alarm on
TROUBLESHOOTING GUIDE
POSSIBLE CAUSES AND/OR REMEDY
Range is not connected to electrical power. Ask a professional to
check power circuit breaker, wiring and fuses.
Oven is still in self-clean mode. Door latch will release when safe
temperature is reached.
Light bulb is burned out.
Oven is not connected to power.
Clean cycle is on.
Turn the oven off at the circuit breaker and wait 5 minutes. Turn
breaker back on. The oven should reset itself and will be operable.
Check the circuit breaker or fuse box to your house.
Make sure there is proper electrical power to the oven.
Make sure the oven temperature has been selected.
Check for obstruction in oven door. Check to see if hinge is bent.
There may be debris/spillage around the lens cover. Wipe lens cover
area with a clean dry towel prior to attempting to remove the lens
cover.
Temperature control knob is rotated too far past broil position
(500°F); PRE-HEATING indicator will light intermittently
This is a FAULT alarm indicating the failure of the cooling fan/s. Try
resetting by turning both selectors to the OFF position. If the error is
not repaired, call a qualified technician for diagnosis and repair. If not
repaired, this error indicator will appear again within 10 seconds once
the oven is activated in any functions for which cooling fans are
required to operate, preventing the use of the oven. Set both
selectors to OFF position and call a qualified technician for repair.
This is a FAULT indicating failure of the oven sensor temperature
probe; in this case cooling fans will start automatically. To reset,
switch both selector to the OFF position. To stop buzzer and light
indicator, disconnect the appliance from the main electrical supply
and call a qualified technician for repair.
Electrical power failure happening during cleaning cycle operation;
cleaning cycle interrupted; cooling fans remains both activated; the
error will be reset by putting two selectors in OFF position; repeat
cleaning cycle if needed after 3-4 hours.
Interruption/Stop of an incomplete cleaning cycle due to a intentional
or accidental displacement of one of the two oven selectors from
CLEAN position during cleaning cycle operation; put both selectors in
OFF position, wait that door latch unlocks the door when oven
temperature is dropped below 500°F(260°C) and then re-select a
desired oven function.
Wrong temperature knob selection in oven functions BROILER or
CONVECTION BROILER (temperature knob positioned not at 500°F
position, over Tmax or under 450°F position); select OFF position
and then 500°F on temperature selector;
Or
Wrong temperature knob selection for oven functions BAKE,
CONVECTION BAKE; TURBO, CONVECTION (temperature knob
positioned over Tmax=500°F position); select OFF position and then
the desired temperature under Tmax position on temperature
selector.
28
Hide quick links:
Advertisement
Table of Contents
