Transportation Instructions; Step 4: Plastic Parts - Spirit XT385 Owner's Manual

STEP 4: Plastic Parts

1. Attach the lower half of the bottle holder (Right - 66) and (Left - 67) to the right and left Uprights (4) and (5)
and Console Support (6) with ten Sheet Metal Screws (122) using the Phillips Head Screw Driver (148).
HARDWARE
#122. 3.5 x 12mm
Sheet Metal Screw
(10 pcs)
10
XT385
T readmill
7
6
Do not attempt to move the unit unless it is in the folded and locked position. Be sure the
power cord is secured to avoid possible damage. Use both handrails to maneuver the unit to the
desired position.
„ TO FOLD THE TREADMILL
Make certain the treadmill is at minimum
incline. Lift the treadmill running deck
until it is secured by the locking telescoping
tube assembly in center back of base.
„ TO UNFOLD THE TREADMILL
Apply slight forward pressure* on the treadmill run-
ning deck with one hand. Pull down on the unlocking
lever and slowly lower the running deck to the floor.
The deck will lower
unassisted when it reaches about waist high.
ƒ *At the rear roller area to relieve pressure on the
locking system.
T ransportation Instructions
The treadmill is equipped with four transport wheels that are engaged when the treadmill is
folded. After folding simply roll the treadmill away.
11
XT385
T readmill