Acer Aspire M5200 Service Manual page 43

Pc
Hide thumbs Also See for Aspire M5200:
Table of Contents

Advertisement

The following table describes the parameters found in this menu.
Parameter
Onboard FDC
Controller
Onboard
Serial Port 1
UR2 Duplex
Mode
Onboard
Parallel Port
Parallel Port
Mode
ECP Mode
used DMA
Description
Select Enabled if your system has a floppy
disk controller (FDC) installed on the system
board and you wish to use it. If you install an
add-in FDC or the system has no floppy
drive, select Disabled in this field.
Select a logical COM port name and
matching address for the serial port. Select
an address and corresponding interrupt for
the serial port.
In an infrared port mode, this field appears.
Full-duplex mode permits simultaneous
tow-direction transmission. Half-duplex
mode permits transmission in one direction
only at a time. Select the value required by
the IR device connected to the IR port.
Select a logical LPI port address and
corresponding interrupt for the physical
parallel port.
Select an operating mode for the onboard
parallel (printer) port.
This item allows users to manually set the
DMA channel for ECP mode
Options
[Enabled]. [Disabled]
[xxx+IRQx]
[Normal], [EPP],
[EPP], [EPP+ECP]
37

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Aspire m3200Aspire m1200

Table of Contents