Table of Contents
Advertisement
2.0 Connecting and Charging the Player
2.1
Connecting and Disconnecting the Player from Your Computer
To connect the player to your computer:
1. Turn the player ON.
2. Use the included USB cable to connect the player to your computer. Plug
the small end of the included USB cable into the player, and the large end
into the computer's USB port.
The first time you connect the player to your computer; the computer will
automatically detect it and install any necessary drivers. When it has finished, the
player will appear in My Computer as EMATIC MP3
To safely disconnect the player from your computer, click the green arrow in the
system tray (the area by the clock on your task bar), which will display a list of
attached USB devices. Select the player in the list to be removed. Windows will
display a message when it is safe to remove the player.
WARNING: Any USB device that stores data (e.g. flash drives, cameras, and
media players) should always be disconnected from your computer using this
method to avoid corrupting the stored data.
2.2
Charging the Battery
The player has a built-in battery that must be charged before the player can be
used.
1. Turn the player ON.
2. Connect the player to a computer using the USB cable (the computer
must be ON for the player to charge properly).
3. Let the player charge for 4 hours before initial use. You can charge
the player for 2 hours per recharge cycle thereafter.
4. Disconnect the player from the computer using the safe removal
method. See "Connecting and Disconnecting the Player from Your
Computer" in this manual.
E5 Series User Manual
4
35
Page
of
Advertisement
Table of Contents
