Installation - Jensen JiSS-600i User Manual

INSTALLATION

CONNECTING THE AC POWER
An AC-DC Adaptor with 7.5V DC 2400mA output (included) is required for
operating the main unit. Plug the AC-DC Adaptor into the unit and into an AC
outlet:
1.) Firmly and securely insert the DC plug of the adaptor into the DC Jack on the back of
the unit
2.) Plug the Adaptor plug into an outlet rated at 120V ~ 60Hz.
NOTE: This speakers are not magnetically shielded and may cause color
distortion on the screen of some TVs or video monitors. To avoid this, you may
need to move the speakers further away from the TV or monitor if unnatural color
shifts or image distortion occurs.
POWER OF INDIVIDUAL SPEAKER
Each speaker has a built-in rechargeable lithium battery for independent playback.
Before the first use, we recommend to charge each speaker battery for 12 hours.
Switch off the speaker power and place it on the recessed charging area of the
powered Docking Base, charging will start automatically. The charging LED
indicator will be flashing green while the speaker is
charging and will switch to solid green when charged.
REMOTE CONTROL
The remote control operates on one CR2025 battery
(included). To activate the remote control, remove the
insulation tab inserted in the battery compartment.
When the operation of the remote control becomes
intermittent or unsatisfactory, replace the original
battery with a new 3-volt lithium CR2025 battery.
1.) Slide out the battery holder from the remote control
case.
2.) Replace the 3V CR2025 battery. Be sure the battery is installed correctly. The
8