Advertisement
A.B.S. Curved Back w/o Mounting Hardware
Tilt Only (2GT)
(After 10/31/00)
NOTE: Wheelchairs with serial number dated for 2005 and after, call a Customer Service Parts Specialist
for additional information on ordering a warranty ABS Back Pan replacement.
NOTE: Overall back height is calculated by measuring from the seat pan surface to the top of the back
pan. Back pan material height can be calculated by subtracting 3-3/4" from the overall back height listed.
Material height listed is rounded off to the nearest whole number.
NOTE: After 10/31/00 spacing between the seat pan and the lower side of the back pan was decreased 3"
by adding 3" to the back pan material. Overall back height did not change.
NOTE: A.B.S. curved backs do not retrofit to the 7/8" round canes. Key slotted back canes and back
attaching hardware must be ordered.
NOTE: Hook Fastener Adhesive Kit must be ordered when a Back Pan or Back Assembly is requested.
This will allow the Loop Fastener Adhesive on the Back Cover to attach properly.
#3 Back Assembly w/o Hardware 20" Wide - 22" Wide
Overall
Material
Back
Back
20" W
21" W
22" W
Height
Height
1090635-NLA
1090636-NLA
1090637-NLA
25"
21"
See Note(s) A
See Note(s) A
See Note(s) A
NOTE:
A - No Longer Available. Must be ordered as separate components, item 1 (Back Pan) and item 2 (Back Cushion Assembly).
58
Form No. 99-150
To order call toll free 1-800-333-6900, or www.invacare.com
Advertisement
