Install The Log Assembly - Hearth and Home Technologies TWILIGHT-II-B Owner's Manual

F. Install the Log Assembly
4 4
3 3
5 5
2 2
CAUTION:
Logs are fragile! Carefully remove the logs
from the packaging. Remove the cardboard support from
inside of fi replace.
INDENT INDENT
INDENT INDENT
STEP 2.
LOG #1 (SRV2005-701): Use the indent on the bottom side of the log to position the large end of the log onto
the grate bar as shown. Slide the log back until the indent engages the grate tine as shown above. Position the thin end of
log #1 one inch from port pattern as shown.
GRATE BAR CUTOUT GRATE BAR CUTOUT
STEP 3.
LOG #2 (SRV2005-700): Position log #2 on the left grate bar and the pilot assembly. Use the cut out notches
on the log to position it as shown.
34 Outdoor Lifestyles by Hearth & Home Technologies, Inc. • Twilight-II-B • 2108-900 Rev. V • 5/11
1 1
6 6
BOTTOM VIEW BOTTOM VIEW
BACK VIEW BACK VIEW
PILOT PILOT
ASSEMBLY ASSEMBLY
CUTOUT CUTOUT
Log Set Assembly: LOGS-MSR
PILOT ASSEMBLY PILOT ASSEMBLY
STEP 1.
Before positioning the logs, refer to the installation
manual for electric ember set-up and ember placement.
1-inch 1-inch
2 2
GRATE TINE (HIDDEN) GRATE TINE (HIDDEN)
1 1
GRATE GRATE
BAR BAR
1 1
2005-937F