Table of Contents
Advertisement
C. Intellifi re Ignition System Wiring
• Wire the appliance junction box to 110 VAC for proper
operation of the appliance.
WARNING! Risk of Shock or Explosion! DO NOT wire
IPI controlled appliance junction box to a switched circuit.
Incorrect wiring will override IPI safety lockout.
• Refer to Figure 9.1, Intellifi re Pilot Ignition (IPI) Wiring
Diagram.
• This appliance is equipped with an Intellifi re control valve
which operates on a 3 volt system.
• Plug the 3-volt AC transformer into the appliance junction
box to supply power to the unit OR install two D cell
batteries (not included) into the battery pack before use.
NOTICE: Batteries should not be placed in the battery
pack while using the transformer. Remove batteries before
using the transformer, and unplug the transformer before
installing the batteries. Battery polarity must be correct or
module damage will occur.
PLUG-IN
3V TRANSFORMER
ON/OFF
WALL
SWITCH
IGNITION
MODULE
(3V)
VALVE
NEUTRAL
BLACK WIRE CAN BE
PLUGGED INTO ANY OF
#1 - #5 LOCATIONS
ON THE HOT SIDE
NOTE: 1. Ignition module, valve, pilot, and wall switch operate on 3 volts.
Uninterrupted 120 VAC is required at junction box unless equipped with battery back-up.
Figure 9.1 Intellifi re Pilot Ignition (IPI) Wiring Diagram
Outdoor Lifestyles by Hearth & Home Technologies, Inc. • Twilight-II-B • 2108-900 Rev. V • 5/11
FLAME SPARKER/
SENSOR
LOW VOLTAGE
SEE NOTE 1
GROUND
REMOTE
CONTROL
HOT
WHITE WIRE
CAN BE
PLUGGED
INTO ANY
OF #1-#5
LOCATIONS
ON THE
NEUTRAL SIDE
PLUG IN
IGNITION MODULE
3 VAC
PIGGYBACK
ON/OFF SWITCH
TRANSFORMER
3 VAC
INTERMITTENT
I
PILOT
IGNITOR
S
WHT
ORG
GROUND TO
FIREPLACE
CHASSIS
VALVE
27
Advertisement
Table of Contents
