Boss BR-1180 User Manual page 27

The next step is to define the location in time for the edit to affect. CURSOR to LOC and
press ENTER. Here is a break down for parameters you will see in LOC menus. By
default, edit times are defined by measures and beats. If you want to set up your edit
times using hours, minutes, seconds and frames, CURSOR to DISP then press ENTER.
• START- this is the starting measure or starting time for the edit.
• END- this is the ending measure or ending time for the edit.
• TO- this is the new location for the edited material when you are doing a track
COPY or track MOVE.
• FROM- this is the location that you are copying or moving from. Usually you will
be copying FROM the START. In that case START and FROM will be the same
number.
• COPY X- this will be the number of times that you want the audio between the
START and END points to copy.
TIP: The easiest way to enter values in for your edit times is to cue up each of the edit
points in your song and press MARK. This will create a marker. Once you have created
markers for all of your edit points you can CURSOR to any place that you need to enter a
value and use the SEARCH left and right arrows to enter in that marker's time. It will fill
in the number for you.
To select an entire track CURSOR to ALL and press ENTER.
After you have all of your values entered CURSOR to GO then press ENTER to perform
the edit. Always go back and listen to your edit. If you don't like what you hear press
UNDO.
The BR-1180 Owner's Manual has a step by step walk through for every track edit
on pages 66-74.
26