Advertisement
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Rocktron Velocity 120
Summary of Contents for Rocktron Velocity 120
- Page 1 May be covered by one or more of the following: U.S. Patents #4538297, 4647876, 4696044, 4745309, 4881047, 4893099, 5124657, 5263091, 5268527, 5319713 and 5333201. Other patents pending. Foreign patents pending.
- Page 2 ® ® ® ° ° ° ° The exclamation point symbol, which appears on The lightning flash with arrowhead symbol, the rear panel of the unit, is intended to alert the appearing on the rear panel of the unit, is intended to alert the user of this product of the user of this product to the presence of important RISK OF ELECTRIC SHOCK...
-
Page 3: Table Of Contents
Introduction ..............1 Front Panel ..............2 Rear Panel ..............3 Connections ..............4 Stereo Applications ................ 4 Mono Bridged Applications ............. 5 Operating Precautions ..........6 Power Output/Speaker Load ............6 Fuse Replacement ................. 7 Unique Features ............8 Automatic Short Detection .............. -
Page 4: Introduction
® ® ®... -
Page 5: Front Panel
This switch powers up the Velocity 120. ® 120 is powered and When lit, this LED indicates that the Velocity ® ready for operation. This control determines the output level for Channel 1. This control determines the level of definition for Channel 1. Turning this control fully counter-clockwise bypasses the Definition circuit, while turning it fully clockwise provides maximum Definition. -
Page 6: Rear Panel
These standard ¼" jacks provide outputs for Channel 2 to speaker cabinets. Do not connect these outputs to a load of less than 4 ohms (or less than 8 ohms in mono-bridged mode). These jacks are inoperable when using the Velocity 120 in "bridged"... -
Page 7: Connections
Stereo Applications... -
Page 8: Mono Bridged Applications
Mono Bridged Applications... -
Page 9: Operating Precautions
* Note: Rocktron does not recommend using the Velocity 120 in bridged mode when connected to a load of less than 8 ohms. However, using the Velocity 120 in bridged mode with an 8 ohm load produces the same output level (120 watts) as would be achieved with a 4 ohm load - therefore using a 4 ohm load would provide no additional benefits. -
Page 10: Fuse Replacement
Fuse Replacement ® Use a small flat screwdriver as shown to slide the fuse cover out from the power inlet module. The fuse can be found inside the fuse cover module after it is pulled out. Note: A small compartment is also provided within the fuse cover module for storing a spare fuse. -
Page 11: Unique Features
Automatic Short Detection ® ® Definition Control...
Need help?
Do you have a question about the Velocity 120 and is the answer not in the manual?
Questions and answers