Table of Contents
Advertisement
2
.
2
.
4
D
e
t
a
i
l
C
2
.
2
.
4
D
e
t
a
i
l
C
The function of Detail Counter collects any information and provides the counting about
the traffic of the port, no matter the packet is good or bad.
In the following figure, the window can show only one port counter information at the
same time. To see another port's counter, you have to pull down the list of Select, then you
will see the figures displayed about the port you had chosen.
Each data field has 20-digit long. If the counting is overflow, the counter will be reset and
restart counting. The data is updated every time interval defined by the user. The valid
range is 3 to 10 seconds. The Refresh Interval is used to set the update frequency. Default
update time is 3 seconds.
Function name:
Detail Counter
Function description:
Display the detailed counting number of each port's traffic. In the following figure, the
window can show all counter information of each port at one time.
Parameter description:
Rx Packets:
Rx Octets:
Rx Unicast:
Rx Broadcast:
Rx Pause:
RX 64 Bytes:
RX 65-127 Bytes:
RX 128-255 Bytes:
RX 256-511 Bytes:
VigorSwitch G2240 User's Guide
o
u
n
t
e
r
o
u
n
t
e
r
The counting number of the packet received.
Total received bytes.
Show the counting number of the received unicast packet.
Show the counting number of the received broadcast packet.
Show the counting number of the received pause packet.
Number of 64-byte frames in good and bad packets received.
Number of 65 ~ 127-byte frames in good and bad packets
received.
Number of 128 ~ 255-byte frames in good and bad packets
received.
Number of 256 ~ 511-byte frames in good and bad packets
received.
43
Advertisement
Table of Contents
