Page 2
VigorSwitch G2100 Quick Start Guide Rack Mount Kit (brackets) Console Cable The type of the power cord depends on the country that the switch will be installed. UK-type Power Cord EU-type Power Cord USA/Taiwan-type Power Cord AU/NZ-type Power Cord If any of these items is found missing or damaged, please contact your local supplier...
Page 3
RJ45 LNK/ACT CONSOLE LNK/ACT Port 1 to Port 8 Status Explanation On (Green) The device is connected with 1000Mbps. RJ 45 LNK/ACT On (Amber) The device is connected with 10/100Mbps. Port 1 ~ 8 Blinking The system is sending or receiving data through the port. The port is disconnected or the link is failed.
Page 4
Before starting to configure the device, you have to connect your devices correctly. A hierarchical network with minimum levels of devices may reduce the timing delay between server and client station. Basically, this approach will minimize the number of devices in any one path; will lower the possibility of network loop, and will improve network efficiency.
Page 5
Before using the switch, perform the following steps: 1. Set up a physical path between the configured the switch and a PC by a qualified UTP Cat. 5e cable with RJ-45 connector. If a PC directly connects to the switch, you have to setup the same subnet mask for Default values of the managed switch are listed as follows: PC and the switch.
Web registration is preferred. You can register your Vigor router via https://myvigor.draytek.com. & & Due to the continuous evolution of DrayTek technology, all switches will be regularly upgraded. Please consult the DrayTek web site for more information on newest firmware, tools and documents. https://www.draytek.com...
Page 7
Calvin Ma / President . (place) (date) (Legal Signature) Declaration of Conformity We DrayTek Corp. , office at No.26, Fushing Rd, Hukou, Hsinchu Industrial Park, Hsinchu 303, Taiwan, declare under our sole responsibility that the product Product name: 8+2 Gigabit Switch ...