Battery Temperature Sensor Installation; Wiring The Inverter To The Battery Bank - Apollo Solar 3224 User Manual

3) la tension CC et la polarité Correcte a été vérifiée.
Place the batteries as close as possible to the inverter, preferably in an insulated and ventilated
enclosure. Allow adequate space above the batteries to access the terminals and vent caps (if
flooded cells). Allow at least 1 inch of space between batteries too promote air flow. Avoid mounting
the batteries directly under the inverter.
When wiring the batteries in either series or parallel (or combination) use a wire size appropriate to the
charge/discharge current.

4.3.1.3 Battery Temperature Sensor Installation

Remove backing strip from adhesive on Battery Temperature Sensor, and attach to the side of one of
the batteries in the bank (toward the center is preferable).
IMPORTANT
Do not attach to a battery terminal.
Plug the 4pin modular plug into the jack labeled Battery Temperature Sensor on the left side of the
Inverter.
IMPORTANT
N'attachez pas à une borne de batterie. Branchez la prise 4pin modulaire au cric marqué sonde de
température de batterie de l'aile gauche de l'inverseur.

4.3.1.4 Wiring the Inverter to the Battery Bank

IMPORTANT
The DC overcurrent device (i.e. circuit breaker) must be wired in the positive DC cable line
between the inverter's positive DC terminal and the battery positive terminal.
IMPORTANT
Le dispositif de surintensité de C.C (c.-à-d. disjoncteur) doit être câblé dans la ligne positive de
câble de C.C entre la borne positive du C.C de l'inverseur et la borne positive de batterie.
IMPORTANT
The shunt must be wired in the negative DC cable line between the inverter's negative DC
terminal and the battery negative terminal as close to the inverter as possible.
IMPORTANT
Le shunt doit être câblé dans la ligne négative de câble de C.C entre la borne négative du C.C de
l'inverseur et la borne négative de batterie aussi étroitement à l'inverseur comme possible.
- 21 -