Installing Flue Components - Heat & Glo LCOR-HVB-CE Installer's Manual

B. Installing Flue Components
After determining which direction the 45
follow flueing instructions accordingly.
• This fireplace comes ready to flue horizontally. Before
attaching additional flue pipe, inspect 45
connection to unit starting collar, if required, snap
in place.
• To flue off the unit vertically, the elbow cover plate must
first be removed from the unit (see Figure 17).
• The elbow can be removed from the unit by aligning the
seams of the elbow to the arrows on the surrounding
heat shield (see Figure 18).
• Position the elbow in the vertical position. Snap in place
with the starting collar.
• Replace the elbow cover plate aligning it with the elbow
and secure in place with the 8 screws.
• Place the rope ring around the first section of pipe and
slide it up against the cover plate.
NOTE: The rope ring is needed for the heat manage-
ment and to prevent cold air infiltration.
ELBOW COVER PLATE
Figure 17
O
elbow will be used
O
elbow
Heat & Glo • PIER/ST/L&RCOR-HVB-CE • 2068-900 Rev. H • 6/07
HEAT
ARROWS
SHIELD
FRONT VIEW
Figure 18
1. Attach the First Flue Component to the
Starting Collars
To attach the first flue component to the starting collars of
the fireplace:
• Slide the first flue section onto the unit and push in until
they snap lock in position.
• Rotate this section to the desired position.
• Using the two tabs provided on the elbow cover plate,
secure the first section of flueing to the fireplace with two
screws.
Refer to Cinch Pipe and Termination Cap installation
instructions.
If the installation is for a termination cap attached directly
to the fireplace, skip to the sections, Install Firestops and
Flue Termination.
ELBOW
ELBOW SEAM
TOP VIEW
27