Troubleshooting; Problems When Installing The Driver - Roland Cakewalk A-500S Owner's Manual

Troubleshooting

If you experience problems, read this chapter first. It contains information that will help you solve the problem.
* For help with Windows or Macintosh operation, refer to the documentation for your computer or operating system.

Problems when installing the driver

Can't start up the installer
Is the CD-ROM inserted correctly in your CD-ROM drive?
Make sure that the CD-ROM is correctly inserted in the CD-ROM drive.
Could the CD-ROM itself or the lens of your CD-ROM drive be dirty?
The installer may not operate correctly if the CD-ROM or the lens of your CD-ROM drive is dirty. Use a commercially
available CD cleaner or lens cleaner to clean the disc or lens.
Are you attempting to install from a networked CD-ROM drive?
The driver cannot be installed from a CD-ROM drive on the network.
A warning or error appears during the installation (Windows)
Could you have connected the A-500S to your computer before installing the driver?
If you connect the A-500S to your computer before installing the driver, an error message may appear when you
begin the installation.
Uninstall the A-500S driver as described in "Removing the driver" (p. 55), and then install the A-500S driver once
again as described in "Driver Installation and Settings" (p. 13).
Are there any devices labeled "Other," "Unknown," or "?/!/X" in the Device Manager?
If driver installation was not completed successfully, the partially installed driver may remain in an incomplete state.
Uninstall the A-500S driver as described in "Removing the driver" (p. 55), and then install the
A-500S once again as described in "Driver Installation and Settings" (p. 13).
62