Macintosh Users; Installing The Driver - Roland Cakewalk A-500S Owner's Manual

Driver Installation and Settings

Macintosh users

Steps to be performed on the A-500S itself are marked by a
Do not connect the A-500S to your computer until you are directed to do so.

Installing the driver

* If the Authenticate dialog box or the dialog that indicates "Installer requires that you type your password" appears
during the installation, enter your password and click [OK].
* What you actually see on the screen may differ depending on your system.
1.
Start up your computer with the A-500S disconnected.
* Disconnect all USB cables other than those for a USB keyboard and/or USB mouse (if used).
2.
Close all currently running software.
3.
Insert the included A-500S CD-ROM into your CD-ROM drive.
4.
Double-click one of the following icons on the CD-ROM to start up the installer.
Mac OS X 10.6 or later
Mac OS X 10.5 or earlier
A message concerned with checking whether installation is possible may appear. If so, click [Continue].
If a message indicating that installation is not possible appears, check the operating system you're using, and
perform step 4.
5.
The screen will indicate "Welcome to the A-500S Driver Installer."
Click [Continue].
6.
If the display indicates "Select a Destination," click your start-up disk to select it, and then click
[Continue].
7.
The screen will indicate "Easy Install" or "Standard Install."
Click [Install] or [Upgrade].
8.
The screen will indicate "Installing this software requires you to restart your computer when the
installation is done."
Click [Continue Installation].
20
OS
[A500S_USBDriver.pkg] (/Driver/10.6)
[A500SUSBDriver.pkg] (/Driver/10.4_10.5)
symbol.
Operation of the A-500S
Installer