Roland V-Drums TDW-20 Owner's Manual page 5

Expansion board for td-20
Table of Contents

Advertisement

Available languages

Available languages

• Do not open or perform any
internal modifications on the
product. (The only exception
would be where this manual
provides specific instructions
which should be followed in
order to put in place user-
installable options; see p. 13.)
...............................................................................................
• Do not attempt to repair the
product, or replace parts within
it (except when this manual
provides specific instructions
directing you to do so). Refer all
servicing to your retailer, the
nearest Roland Service Center,
or an authorized Roland
distributor, as listed on the
"Information" page.
...............................................................................................
• Do not allow any objects (e.g.,
flammable material, coins,
pins); or liquids of any kind
(water, soft drinks, etc.) to
penetrate the TD-20.
...............................................................................................
• Never install the product in any
of the following locations.
• Subject to temperature
extremes (e.g., direct
sunlight in an enclosed
vehicle, near a heating duct,
on top of heat-generating
equipment); or are
• Damp (e.g., baths,
washrooms, on wet floors);
or are
• Exposed to steam or smoke;
or are
• Subject to salt exposure; or
are
• Humid; or are
• Exposed to rain; or are
• Dusty or sandy; or are
• Subject to high levels of
vibration and shakiness.
...............................................................................................
• In households with small
children, an adult should
provide supervision until the
child is capable of following all
the rules essential for the safe
operation of the product.
...............................................................................................
• Protect the product from
strong impact.
(Do not drop it!)
...............................................................................................
• Before installing the TDW-20,
you must first always turn off
the TD-20 and unplug its power
cord.
• Never step on, nor place heavy
objects on the product.
...............................................................................................
• Install the circuit board only
into the specified product (TD-
20). Remove only the specified
screws during the installation.
...............................................................................................
• Keep any screws you may
remove and the included
installation tool in a safe place
out of children's reach, so there
is no chance of them being
swallowed accidentally.
...............................................................................................
5

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents