Fujitsu AD11 Manual page 6

AD11 Mainboard Manual
In addition, the 1stMainboard AD11 is equipped with 2 dual channeled en-
hanced PCI bus master IDE connectors. Standard I/O connections include 2
serial ports, 1 parallel port, 1 PS/2 mouse and keyboard connector, 2 USB
connectors, 2 front USB pin-headers, and 1 media connector ( Line-In, Line-
Out, Mic-In, 1 Midi/game port).
IMPORTANT: AMD CPU HEAT SINK INSTALLATION
Be ware finish heat hink install. Before you boot system, please
check the heat sink is complete contact with die of CPU.
The poor contact will bring about over heat, it may damage your
processor.
It is strongly recommended that at least a 200-watt ATX power pupply
be used for this motherboard. Make sure that your ATX power sup-
ply can supply at least 20 amperes on teh +5-Volt lead and 10ma
on the +5-Volt standby lead (+5VSB). Your system may become
unstable / unreliable and may experience difficulty in powering up if
your power supply is inadequate.
1 - 2