Fujitsu AD11 Manual page 57

RTC Resume
Enabled allows you to set the time the system will be turned on from the
system power-off status. The options are: Enabled, Disabled.
Date (of Month)
This feature allows you to set the day of the alarm starts when the RTC
Alarm Resume From Soft Off is set to be Enabled. The options are: 0, 1..31.
Time (hh:mm:ss)
When RTC Alarm Resume is Enabled, this feature allows you to set the
time of the alarm starts when the RTC Alarm Resume From Soft Off is set to
be Enabled.
The options are: 7: 0: 0. hh (hour) - 0, 1, 2,.., 23; mm (minute) - 0, 1, 2,..,59;
ss (second) - 0, 1, 2,..,59.
IRQ Wakeup Events -
IRQs Activity
If the IRQ activity which is defined as Primary occurs, the system goes
back to Full-on Mode directly. If the IRQ activity which is defined as
Secondary takes place, the system enters another low power state, Dream
Mode, in which the system will act as Full-on Mode except that the screen
display remains off until the corresponding IRQ handler finishes, then
back to Suspend Mode. The options are: Disabled, Primary, Secondary.
IRQ 3/.../15
After the time period which you set, the system advances from doze mode
to suspend mode in which the CPU clock stops and the screen display is
off. At this moment, if the IRQ activity occurs, the system goes back to
full-on mode directly.
If the IRQ activity which is defined as Non Primary takes place, the system
remains off until the corresponding IRQ handler finishes.
The options are: Enabled, Disabled.
BIOS Setup
3 - 21