Bandwidth Control; Control Settings - TP-Link TL-WR1043ND User Manual

Subnet Mask - The Subnet Mask determines which portion of an IP address is the network
portion, and which portion is the host portion.
Gateway - This is the IP address of the gateway device that allows for contact between the
Router and the network or host.
Interface - This interface tells you either the Destination IP Address is on the LAN & WLAN
(internal wired and wireless networks), or on the WAN (Internet).

4.14 Bandwidth Control

Figure 4-78 Bandwidth Control
There are two submenus under the Bandwidth Control menu as shown in Figure 4-78: Control
Settings and Rules List. Click any of them, and you will be able to configure the corresponding
function. The detailed explanations for each submenu are provided below.

4.14.1 Control Settings

Choose menu "Bandwidth Control → Control Settings", and then you can configure the
Egress Bandwidth and Ingress Bandwidth in the next screen. Their values you configure should
be less than 100000Kbps. For optimal control of the bandwidth, please select the right Line Type
and ask your ISP for the total bandwidth of the egress and ingress.
Enable Bandwidth Control - Check this box so that the Bandwidth Control settings can take
effect.
Line Type - Select the right type for you network connection. If you don't know how to choose,
please ask your ISP for the information.
Egress Bandwidth - The upload speed through the WAN port
Ingress Bandwidth - The download speed through the WAN port.
TL-WR1043ND
Figure 4-79 Bandwidth Control Settings
-86-
Wireless N Gigabit Router
.