Table of Contents
Advertisement
connection
The cleaner doesn't need an earth. It has a 13A BS1362 fuse in a 13A
BS1363 plug. To replace the plug, fit the blue wire to N, and the brown
wire to L. Fit the cord grip. If in doubt, call an electrician.
Don't use a non-rewireable/moulded plug unless the fuse cover is in place.
If you remove the plug, dispose of it.
before using for the first time
Remove the packaging, but keep it till you're sure the cleaner is working properly.
filters
It's vital you keep the filters clean. If the filters get blocked, you'll lose suction rapidly.
We've made them easy to remove, and easy to clean – the rest is down to you.
count the bits
In the box you'll find a big brush, hose (with nozzle), extendable tube and crevice
tool/small brush. They may be packed separately, so check the packaging before you
dispose of it. The crevice tool/small brush may be mounted in its slot between the
wheels.
fitting the hose
1 Turn the hose end, to align the locks on either side with the notches in the inlet.
2 Push the hose end into the inlet. You'll hear a click as it locks into position.
3 Give it a gentle tug to check it's fitted properly.
cable
4 Pull as much cable as you need from the back of the cleaner.
5 There's a yellow band round the cable to show there's about a metre left.
6 There's a red band about half a metre later. This means "Stop pulling, you've run out
of cable!" If you're very strong, and you keep pulling, you could probably haul the
cable right out of the cleaner – this is not a good idea.
7 Keep an eye on the cable so it doesn't catch on anything, and doesn't trip anyone
(including you).
carrying and moving the cleaner
8 Lift the cleaner only by the handle.
9 When you lower the cleaner, make sure it's sitting on the floor before you let the
handle go – this might sound obvious, but with such a small cleaner you might be
tempted to drop it a little, instead of bending all the way down to the floor. Don't,
you'll damage it.
10 When the cleaner is sitting on its wheels (normal position), you can move it around
by pulling gently (that's gently), on the hose.
11 For stationary jobs like curtains, sit the cleaner on its back, with the inlet uppermost,
but don't try to move it around like this, it'll fall over.
choose the tool for the job
12 The big brush and crevice tool/small brush will fit on the nozzle, or on the end of the
extendable tube. The extendable tube fits on the end of the nozzle.
4
Advertisement
Table of Contents
