Setting The Clock - Kenmore 790.7890 Use & Care Manual

Setting the Clock

Setting the Clock
The pad is used to set the clock. The clock may be set for 12 or 24 hour time of day operation. The clock has been preset
at the factory for the 12 hour operation. When the range is first plugged in, or when the power supply to the range has been
interrupted, the time in the display will flash.
Press . The display will stop flashing.
To set the clock (example below for 1:30)
1. Press . "CLO" will appear in the display (Fig. 1).
1 3 0
2. Press pads to set the time of day to 1:30 (Fig. 2). Press
The time of day will appear in the display (Fig. 3).
Changing between 12 or 24 hour time of day display
1. Press and hold for 7 seconds until "12Hr" or "24Hr" appears in
the display.
2. Press to switch between the 12 and 24 hour time of day display.
The display will show either "12Hr" (Fig. 4) or "24Hr" (Fig. 5).
3. Press to accept the change or press
4. Reset the correct time as described in To set the Clock above. Please
note that if the 24 hour time of day mode was chosen, the clock will
now display time from 0:00 through 23:59 hours.
INSTRUCTIONS
.
to reject the change.
13
PRESS
1 3 0
for 7 seconds
or press
DISPLAy
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5