Advertisement
Assembly
requires
two persons.
Hace the treadmHUin a cbared area and remove aH packing matedaUs, Do not
dispose of the packing matedab until the treadmHUis assembbd,
Note: The underside of the treadmHUwaUking beUtis coated with high-performance
Uubdcant, During shipping, a
small amount of Uubdcant may be transferred to the top of the waUking beUt,the sides of the waUking pUatform, or
the shipping carton, This does not affect treadmHUperformance, ff there is Uubdcant on top of the waUking belt or
on the sides of the walking platform, wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner,
Assembly
requires
the included
allen wrench
_ and your own philtips
screwdriver
(_.
1, With the help of a second person, carefully raise the
Uprights (65) to a vertical position,
Have the second person hold the consob assembly near
the Uprights (65) as shown, Look under the console as-
sembly and locate the Console Wire Harness (71),
Cut the plastic ties securing the Upright Wire Harness
(85) to the right Upright (65), Connect the Upright Wire
Harness to the Console Wire Harness (71), Make sure to
connect
the connectors
properly
(see the inset draw_
ing}. The connectors
should slide together
easily and
snap into ptace, if the connectors do not slide together
easily and snap into place, turn one connector and try
again, IF THE CONNECTORS
ARE NOT CONNECTED
PROPERLY, THE CONSOLE MAY BE DAMAGED
WHEN THE POWER IS TURNED ON.
Console
Assembly.
65
insert the Wire Harnesses (71,85) down into the right
Upright (65),
Set the console assembly on the Uprights (65), While a
second person holds the console assembly, attach the
console assembly with four Console Bolts (133) and four
Console Washers (69) as shown, Firmly tighten the
Console Bolts,
Console
Assembly
\
85
Advertisement
