Assembly - Healthrider Outlook HRTL89406.0 User Manual

ASSEMBLY

Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials. Do not
dispose of the packing materials until assembly is completed.
Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a
small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal
condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off
the lubricant with a soft cloth and a mild, non-abrasive cleaner.
Assembly requires the included hex key
ber mallet
in parentheses below each drawing is the key number of the part, from the PART LIST on pages 30 and 31. The
number following the parentheses is the quantity needed for assembly. Note: Some small parts may have been
preassembled. If a part is not in the parts bag, check to see if it has been preassembled. To avoid damag-
ing plastic parts, do not use power tools for assembly.
Nut (20)–2
Upper Latch Shock Bolt (4)–1
1. Make sure that the power cord is unplugged.
With the help of a second person, carefully tip
the treadmill onto its left side as shown. Partially
fold the Frame (55) so that the treadmill is more
stable. Do not fully fold the Frame until the
treadmill is completely assembled.
Insert an Extension Leg (97) into the base of the
Uprights (85) as shown. Tighten two Extension Leg
Bolts (87) into the bottom of the Extension Leg.
Attach two Base Pads (81) to the base of the
Uprights (85) with two 1" Tek Screws (82).
With the help of a second person, tip the tread-
mill over onto it's right side. Attach the other
Extension Leg and Base Pads (not shown) as
described above.
With the help of a second person, carefully raise
the treadmill so that all four Base Pads (81) are on
the floor and the Frame (55) is in a vertical position
(see drawing 3).
. For help identifying the assembly hardware, see the drawings below. The number
3/8" Star
Washer (71)–4
Console Bolt (72)–4
and your own phillips screwdriver
1" Tek Screw (82)–4
1
55
7
Lower Latch Shock Bolt (3)–1
Extension Leg Bolt (87)–4
85
81
87
97
, and rub-
81
82