Table of Contents
Advertisement
Changing discharge rate
362D28 is equipped with an outlet volume
changer mechanism. The volume is initially
set to a "High rate" position in our factory.
Depending on your spray condition, change it to
an adequate position.
IMPORTANT
For Flow dust (FD) powder agents and 1kg-
Weed killers, set to the "Small rate" position.
(1) "Small rate" (2) "Medium rate"
(3) "High rate"
(4) Full Open
(5) Full Close
(6) Change arm
(7) Rod
(8) Full Open
(9) Full Close
(10) Adjust lever
(11) Lock Nut
(12) Stopper spring
■ HOW TO CHANGE
1. Pull the rod on backrest side of the chemical tank
holder and disengage from the change arm.
2. Insert the upper end of the rod into the required
position hole.
NOTE
In case the rod length does not match with
the hole position, adjust the length in following
manner:
10 - English
Assembly
1. Put the adjust lever to "Full open" position
2. Push up the change arm with fingers to "Full
open" position.
3. Slacken the lock nut on the lower end of the rod
and turn the rod till the upper end of the rod
come to "High rate" position. Right turn of the
rod shortens it and left turn makes it longer.
Tighten the lock nut after the adjustment.
NOTE
• Inadequate rod length may cause the rod
disengaged or the shutter improperly operated.
• Even for an operation at "Small rate" or "Medium
rate", adjustment of the rod length shall be made
to "High rate" position hole. Otherwise, it may
cause an excessive discharge.
Advertisement
Table of Contents
