Wall-Mounting Placement - Cisco Linksys E1000 User Manual

Linksys E1000

Wall-Mounting Placement

The Router has two wall-mount slots on its bottom panel .
The distance between the slots is 152 mm .
Two screws are needed to mount the Router .
Suggested Mounting Hardware
4-5 mm 1-1 .5 mm
NOTE:
Cisco is not responsible for damages
incurred by unsecured wall-mounting hardware .
Follow these instructions:
1 . Determine where you want to mount the Router . Make
sure that the wall you use is smooth, flat, dry, and
sturdy . Also make sure the location is within reach of
an electrical outlet .
2 . Drill two holes into the wall . Make sure the holes are
152 mm apart .
3 . Insert a screw into each hole and leave 3 mm
of its head exposed .
4 . Position the Router so the wall-mount slots line up
with the two screws .
5 . Place the wall-mount slots over the screws and slide
the Router down until the screws fit snugly into the
wall-mount slots .
Wireless-N Router
2 .5-3 .0 mm
152 mm
Print this page at 100% size .
Cut along the dotted line, and place on the wall to drill precise spacing .
Wall-Mounting Template
Chapter 1: Product Overview
2