Table of Contents
Advertisement
Linksys E1000
Administration > Firmware Upgrade
The Firmware Upgrade screen allows you to upgrade the
Router's firmware . Do not upgrade the firmware unless
you are experiencing problems with the Router or the new
firmware has a feature you want to use .
Administration > Firmware Upgrade
NOTE:
The Router may lose the settings
you have customized . Before you upgrade
its firmware, write down all of your custom
settings . After you upgrade its firmware, you
will have to re-enter all of your configuration
settings .
Firmware Upgrade
Before
upgrading
the
Router's firmware upgrade file from the website,
www.linksys.com/support .
Please select a file to upgrade the firmware
Browse and select the firmware upgrade file .
Start to Upgrade
After you have selected the appropriate
file, click this option, and follow the on-screen instructions .
WARNING:
Do not interrupt the upgrade
process . You should not turn off the power or
press the Reset button during the upgrade
process . Doing so may disable the Router .
Wireless-N Router
firmware,
download
the
Click
Chapter 2: Advanced Configuration
Status > Router
The Router screen displays information about the Router
and its current settings .
Status > Router
Router Information
Firmware Version
The version number of the Router's
current firmware is displayed .
Firmware Verification
The unique identifier of the
firmware is displayed .
Current Time
The time set on the Router is displayed .
Internet MAC Address
The Router's MAC address, as
seen by your ISP, is displayed .
Host Name
The Host Name of the Router is displayed (if it
was entered on the Setup > Basic Setup screen) .
Domain Name
The Domain Name of the Router is
displayed (if it was entered on the Setup > Basic Setup
screen) .
Internet Connection
This section shows the current network information
stored in the Router . The information varies depending on
the Internet connection type selected on the Setup > Basic
Setup screen .
For a DHCP connection, select Release IP Address or
Renew IP Address as appropriate to release or renew
a DHCP lease . For a PPPoE or similar connection, select
Connect or Disconnect as appropriate to connect to or
disconnect from the Internet .
Click Refresh to update the on-screen information .
27
Hide quick links:
Advertisement
Table of Contents
