Advertisement
What Is the AC3?
Use the AC3 8-Slot Battery Charger (Model AC3) to charge up to 8 batteries at one time.
This guide explains how to install and use the battery charger.
What You Need
To use the charger, you need:
•
an AC power supply.
•
an AC power cord.
You need to purchase the appropriate power cord for your location. For more information,
contact your Intermec sales representative.
You must use the appropriate Intermec power supply with this device or
equipment damage may occur.
Charging Batteries
You can charge up to eight AB1G batteries at one time in the charger. The charger fully charges
the batteries in about 5 hours.
To charge batteries
1
With the battery contacts facing the charger,
slide the battery into one of the slots.
2
Push the battery into the slot to engage the
latch. The Status light for that slot changes
from yellow to green or red to indicate the
battery charge status. See "Understanding
the Lights" to learn what the Status light
colors mean.
To remove batteries
•
Press the button for that slot and
slide the battery up and out.
AC3 8-Slot Battery Charger Instructions
Understanding the Lights
This table explains what the different colors of the Status lights mean.
Color
Description
No Color
The battery charger is not receiving power. Make sure the power supply is
connected properly to a powered AC outlet.
Steady Yellow
The battery charger is connected to AC power and is ready to charge.
Flashing Green
The battery is charging.
Steady Green
The battery is fully charged.
Flashing Red
The battery is not charging. Try these solutions:
•
Make sure the battery is firmly installed in the charger.
•
Make sure the power supply is connected properly to a powered
AC outlet.
•
Make sure the charging pins on the AC3 and the battery contacts are
clean.
Advertisement
