Brickcom CB-500A Series User Manual page 12

WPS
Continuous Illumination Continuous Illumination
WPS
Firmware Continuous Illumination Continuous Illumination
Upgrade
Privacy Continuous Illumination Continuous Illumination
Privacy Unlit
Hardware Reset
The Reset Button can be used to reboot the camera or restore it to factory default settings. If The Reset Button can be used to reboot the camera or restore it to factory default settings. If The Reset Button can be used to reboot the camera or restore it to factory default settings. If
the camera experiences a problem, rebooting the camera may correct the problem. If the the camera experiences a problem, rebooting the camera may correct the problem. If the the camera experiences a problem, rebooting the camera may correct the problem. If the
problem remains, please restore the camera to factory default settings and reinstall the
software.
To Reboot - Press and hold the Reset Button for one second using a paper clip or thin object. Press and hold the Reset Button for one second using a paper clip or thin object. Press and hold the Reset Button for one second using a paper clip or thin object.
Wait for the camera to reboot. Wait for the camera to reboot.
To Restore – Press and hold the Reset Button for Press and hold the Reset Button for ten seconds until the LED light turns off.
When successful restored, the LED will be blue during normal operation. When successful restored, the LED will be blue during normal operation. When successful restored, the LED will be blue during normal operation.
NOTE - By restoring the camera, all settings will be restored to the factory default settings. By restoring the camera, all settings will be restored to the factory default settings. By restoring the camera, all settings will be restored to the factory default settings.
Micro-SD/SDHC Card Capacity Card Capacity
The network camera is compatible
Reset Button Reset Button
CB-500A Series
lease restore the camera to factory default settings and reinstall the lease restore the camera to factory default settings and reinstall the
compatible with Micro-SD/SDHC (Maximum 3
Session overlap detected Session overlap detected
WPS success
Firmware successfully Firmware successfully
upgraded
Privacy mask active Privacy mask active
Privacy mask inactive Privacy mask inactive
ten seconds until the LED light turns off.
- 6 -
WCB-500A
/WCB-502A
Fourth (Blue)
WCB-500A
/WCB-502A
Fourth (Blue)
CB-500A
SERIES
Fourth (Blue)
Bottom(Red)
Bottom(Red)
32GB) cards.