Key Operator Functions; Adding Paper To The Drawers - Toshiba e-studio 353 User Manual

KEY OPERATOR FUNCTIONS

How to Add Paper and Toner
Changing the Paper Size of the Drawer
How to Clear a Misfeed
Meter Reading Submissions
Service Calls and Supply Orders
How to Add Paper and Toner

Adding Paper to the Drawers

When the paper in the selected drawer or the large
capacity feeder (optional) runs out, the drawer or large
capacity feeder on the screen blinks, and "Add paper"
appears. Add paper as the following procedure.
1. Pull out the drawer carefully until it comes to a stop.
2. Place paper in the drawer(s).
Place paper face up.
Fan the paper well before placing it in the drawer.
Do not add paper above the line indicated on the
guide.
Do not use creased, folded, wrinkled or damp sheets
of paper.
NOTE: Make sure that a gap of approx. 0.02"
(less than 0.04" in total) is left between the paper and
the side guide. If there is no gap, this could cause
paper misfeeding.
3. Push the drawer straight into the equipment until it
comes to a stop.
Be sure to push the drawer carefully and fully in.
The same procedure can be used to add paper to any
of the drawers in the paper feed pedestal (optional).
Page 15