Table of Contents
Advertisement
9. Depress the two buttons on the sides of the
Handlebar Assembly (6) with your thumb and fore-
finger. Insert the Handlebar Assembly (6) into the
Handlebar Swing Arm (5). Make sure that the but-
tons protrude through one of the two sets of holes
in the Handlebar Swing Arm. Note: The upper holes
offer lower workout resistance; the lower holes offer
higher resistance.
10. Slide the Console (35) fully onto the Main Frame (1)
as shown in inset drawing A. Press down on the
Console as shown in inset drawing B until it snaps
into place.
11. Remove the battery cover from the Console (35).
Insert two AA batteries into the Console, making
sure that the negative ends of the batteries (marked
–) are touching the springs in the battery compart-
ment. Note: Alkaline batteries are recommended.
Reattach the battery cover to the Console (35).
12. Make sure that all parts are properly tightened. To protect the floor or carpet from damage, place a mat
under the HealthRider exerciser.
9
10
35
1
11
(+)
(–)
35
7
6
Buttons
A
35
B
35
Battery
Cover
(–)
(+)
AA
Batteries
Holes
5
1
1
Advertisement
Table of Contents
