Honeywell HMAX082 Owner's Operation Manual page 70

8.3.3 Programming Auto-Sequences, Continued
a. Click on the down arrow beside the MaxCom Icon on the Icon toolbar, then click
b. Click on Configure in the main menu, then MaxCom, then Auto Sequence as
2. Click on the monitor to program. For example, click on Monitor 1. The currently
programmed sequence is displayed for Monitor 1. The cursor is located in the
Stage 1, Camera field.
There are several buttons on the bottom of the window and the side of the window to
assist the user in editing the sequence.
Append – Click on the Append button to add another camera at the end of the
sequence.
Rev. 1
on Auto Sequence as shown in the display below.
shown in the following display.
The Auto Sequence window is displayed. Note: If your MaxCom Gold has only
one monitor, you will only be able to program an auto sequence for Monitor 1.
58 900.0560
18-July-2005