Keyboard Camera Privileges - Honeywell HMAX082 Owner's Operation Manual

8.3.6 Monitor Partitioning, Continued
4. Click on Send to send the revised configuration to the MaxCom Gold. Note: this
step can be done when all programming is completed using the Send Receive
Centre utility.
5. Close the menu by clicking on the X in the upper right corner.

8.3.7 Keyboard Camera Privileges

1. There are two ways to access the Keyboard Camera Privileges programming
window:
a. Click on the down arrow beside the MaxCom Icon on the Icon toolbar, and then
b. Click on Configure in the main menu, then MaxCom, then Keyboard Camera
Rev. 1
click on Keyboard Camera Privileges as shown in the display below.
Privileges as shown in the following display.
69 900.0560
18-July-2005