Section 1: Operation; System Initialisation; Joystick Recalibration; Keyboard Key Press Operation - Honeywell HMAX082 Owner's Operation Manual

1.1 SYSTEM INITIALISATION

During the initialization phase, if the RapidDomes are initialized at the same time, the
RapidDome will display blanked video until initialization is complete; normal video will
then be displayed.
A start-up screen is displayed on the monitor display for approximately 5 seconds. The
start-up screen shows the MaxCom Gold model (e.g. 8/1, 16/2, etc.), the software
compilation date (e.g. Oct 24 2003), and the software version number (e.g. V01.00).
The keyboards automatically self-calibrate the joystick on power-up. The current
position of the joystick is defined at the centre point.
The keyboard(s) connected to the MaxCom Gold are locked upon power-up. The lock
button on the keyboard is illuminated. A user must log on to the MaxCom Gold at the
keyboard to control the system. Refer to section 1.4 to log on to the system.

1.2 JOYSTICK RECALIBRATION

An operator can re-calibrate the joystick at any time after power-up. Perform the
following procedure to calibrate the joystick.
Press the F6 key and the lock button at the same time.
When powering up any connected keyboards please ensure that the joystick is not
touched or moved for the first five seconds. This allows the joystick to fully self calibrate.
Note: It is important that the operator does not move the joystick during this procedure.

1.3 KEYBOARD KEY PRESS OPERATION

Throughout the manual, reference is made to button (key) presses. If you are instructed
to press a button, it means to press then release the button. If a button must be pressed
and held, it will be specified in the instructions.
Rev. 1
SECTION 1:
OPERATION
1 900.0560
18-July-2005