Sharp XV-Z12000 Operation Manual page 36

3
Press , ,
on the remote control or
the projector to select the IN-
PUT mode.
• After pressing
once on the projector,
use to select the desired input mode.
Note
• When no signal is received, "NO
SIGNAL" will be displayed. When a
signal that the projector is not pre-
set to receive is received, "NOT
REG." will be displayed.
• The INPUT mode is not displayed
when "OSD display" is set to "Level
A" or "Level B". (See page 68.)
About the INPUT modes
INPUT 1 Used for projecting images
INPUT 2 from equipment that sends
(Compo- component signals or RGB
nent/RGB*) signals connected to the
INPUT 1 or 2 terminals.
INPUT 3 Used for projecting im-
(S-Video) ages from equipment con-
nected to the S-VIDEO in-
put terminal.
INPUT 4 Used for projecting im-
(Video) ages from equipment
connected to the VIDEO
input terminal.
Used for projecting im-
INPUT 5
ages from equipment
(Digital PC
connected to the DVI in-
RGB/
put terminal.
Digital PC
Component/
Digital Video
RGB/Digital
Video
Component/
Analog RGB/
Analog
Component)
* Input the RGB signal of the DTV, not
the computer.
, or
on
"On-screen Display (Example)
INPUT 1 mode
Using RGB*
Using
Component
INPUT 2 mode
Using RGB*
Using
Component
INPUT 3 mode
Using S-Video
INPUT 4 mode
Using Video
INPUT 5 mode
Using Analog
RGB
The display varies accord-
ing to the "Signal Type" with
the INPUT 5. The diagram
shown above is the ex-
ample of having selected
"Analog RGB".
-35