Setting The Clock; Nuisance Prevention® Circuitry - Clarion UNGO Pro Security S670 Owner's Manual

and it will go out if you are exiting Valet Mode.
To enter or exit Valet Mode using the remote:
Steps 2 through 3 must be quickly and smoothly completed.
1. Open any vehicle door.
2. Press
3. Press
4. Press
The status LED will light solidly if you are entering Valet Mode,
and it will go out if you are exiting Valet Mode.
➜

setting the clock

To set the clock press and hold
ceiver will chirp twice and the hour selection will start flashing.
Immediately press
reverse the hour selection. Once the correct hour is displayed
press again and the minute selection will start flashing.
Then press
reverse the minute selection. Once the correct time is displayed
simply stop pressing any buttons for 15 seconds and the trans-
ceiver will automatically exit the clock mode.
➜
nuisance prevention
Your system has Directed's Nuisance Prevention
(NPC ). It prevents annoying repetitive trigger sequences due to
®
faulty door pin switches or environmental conditions such as
© 2006 directed electronics, inc.
.
.
again.
to advance the hour selection or
to advance the minute selection or
® circuitry
for five seconds, the trans-
®
to
to
Circuitry
23