Huffy 700c Owner's Manual page 14

Seat Installation - continued
CAUTION: Operate the Quick Release Lever (D) by hand only. Do not use a
hammer or any other tool to tighten the quick release lever.
You must use strong force to move the quick release lever to the "close" position. If
you can easily move the lever to the "close" position, the clamping force is too light.
WARNING: If the clamping force of the Quick Release Lever is too light, the
seat post can loosen while riding. This can cause injury to the rider or to others.
Tighten the quick release lever (continued):
• Open and close the Quick Release Lever with one hand while you turn the Ad-
justing Nut (F) with the other hand (fi g 11).
• Tighten or loosen the adjusting nut by hand, so that you fi rst feel resistance to
the quick release lever when it perpendicular to the bicycle frame.
• Push the Quick Release Lever to the "close" position (fi g 11).
• When in the "close" position, make sure the Quick Release Lever lays against
the Seat Post Clamp (E).
• The tightening torque of the Quick Release Lever should be tight enough so that
the seat does not move during normal operation.
Seat Bolt Mount (various models)
Some models have a Allen Head Screw (A) instead of a Quick Release Lever.
• If needed, loosen the Screw enough to insert the Seat Post (32).
• Point the seat forward and insert Seat Post to the Minimum Insertion marks (B).
• Tighten Screw (A) securely so it supports the rider without moving.
14
32
A
B