Table of Contents
Advertisement
Mounting the Lens
1.
Mount the lens by turning it clockwise on the lens mount
of the camera.
2.
Connect the lens cable to the auto iris lens connector on
the rear panel of the camera.
Caution
The lens mount used should be a CS-Mount
(1"-32UN) and the lens weight should be less
than 450 g (0.99 lbs).
Focus and Back Focal Adjustment
The following adjustment should only be done by qualified
service personnel or system installers.
1.
Loosen the back focus adjustment screw on the topside
of the front head.
Figure 7
2.
Move the back focus adjustment screw to the desired
position.
3.
Tighten the back focus adjustment screw to lock it into
place.
Caution
Do not tighten the back focal adjustment screw
too much, otherwise the back focus
mechanized unit might be damaged. Gently
finger tighten only. When using the C-mount
lens, do not rotate the ring counter-clockwise
by force. If the ring is rotated by force, the inner
lens or CCD image sensor may be damaged.
Rev 1.01
Back Focal Adjustment
Back focal adjustment screw
7
900.0355
01/06
Advertisement
Table of Contents
